Via dell'Industria 49, 34075 San Canzian d'Isonzo (GO) - Italy
+39 0481 77 65 42
comunicazione@d-ditaly.com

HYPATEX

Categorie: INFLATABLE RAFTS AND TENDERS and NAUTICAL.

Descrizione

HYPALON is the registered trademark by Du Pont to indicate the chlorosulfonated polyethylene (CSM), a synthetic rubber, which is supplied to the rubber industry, as raw material for processing and vulcanizate in oder to obtain a wide range of finished products.

With Hypalon is produced the trilaminate HYPATEX, composed by:

  • Hypalon
  • fabric (polyester Dtex 1670 or 2200 Dtex)
  • neoprene in the state of pre-extrusion, that is not inflated (CR)

 

Features:

  • Thicknesses 1:00 to 1:25 mm (h 145-150 cm)
  • Weight 1300/1500 gr / m2
  • High resistance to UV rays
  • Anti abrasion treatment
  • Resistant to contact with hydrocarbons
  • Easy to clean

 

HYPATEX TECHNICAL DATA SHEET

 

PRODUCT CODE

THYPRMT2KBLACK – Hypatex thickness 1,25 mm h 152 cm black


THYPRMT1JLWHITE – Hypatex thickness 1 mm h 145 cm white


THYPRMT1JLGREY – Hypatex thickness 1 mm h 145 cm light gray


THYPRTMT1JLGREYD – Hypatex thickness 1 mm h 145 cm dark gray


THYPRMT1JLBLUE – Hypatex thickness 1 mm h 145 cm blue


THYPRMT1JLBLACK – Hypatex thickness 1 mm h 145 cm black


THYPRMT1JLRED – Hypatex thickness 1 mm h 145 cm red

 

The cheaper alternative is BOTEX, composed by PVC-fabric-PVC.

BOTEX TECHNICAL DATA SHEET

 

PRODUCT CODE

TPVCKBT1C0009BI – Botex Pvc thickness  0,9 mm h 152 cm bianco

In combination it is available the BAND-TEX tape: a neoprene strip to weld the internal joints.
The revolutionary diagonal ” cross ” gives elasticity and extensibility, allowing an easier application on curved surface.

Composition: neoprene CR / nylon 420D / neoprene CR.

Available in tapes of 5 cm and 80 cm height.

BGM01A THERMAL BANDS

 

 

 

 

 

TECHNICAL DATA SHEET BAND-TEX

 

PRODUCT CODE

THYPRT050-50 – Band-Tex tape h 5 cm


THYPRT050-800 – Band-Tex sheet h 80 cm


 

INSTRUCTIONS AND ADVICE FOR STICKING

  • Sand and brush the surface to be glued.
  • Pad clean with SOLVEK NG solvent  and wait 5 minutes.
  • Apply a first coat of EUROFIX RAFTS prepared with 5% DESMOUR RFE and let dry for at least 30 minutes.
  • Apply a second coat of the same product used before.
  • Allow to air dry for about 15 minutes and then couple the supports by pressing for 15 seconds to 2 atmospheres.

INSTRUCTIONS AND ADVICE FOR CLEANING

  • Dilute with water a common neutral detergent (such as a hand cleaner, a powder detergent …).
  • Dip a cotton cloth or sponge and clean the surface. Rinse with clean water.
  • Do not reuse the dirty water in any way as it contains elements such as:
    – Waste water (including dust)
    – diesel
    – motor oil